Jockey Journal Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter · #1 ·
out of a cast mag wheel? I tried heating it up, but it didn't budge. Not much on the backside to catch with a drift or punch. Any suggestions?
 

·
Registered
Joined
·
1,309 Posts
run the tig welder around the race. no filler rod, just heat the mother up. lift it out with some needle nose pliers spread apart wide. it'll will basically fall out.

same for neck bearings
 
1 - 8 of 8 Posts
Top