Jockey Journal Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1,128 Posts
Extra thick head gaskets for lower comp, seen hem in jp cycles I think.

Hydro clutch to get rid of ball and ramp clutch set up.

Talk to dragstews for balancing. I am sending my entire bottom mend and cases out to him to send back done. He is in Florida.
 

·
Registered
Joined
·
1,128 Posts
The ball and ramp setup will not stay adjusted for longer than a week at most. The hydro clutch will let you shift through easy and glide into neutral. If you want to keep the master cylinder off of the handlebars put a remote master on the frame with a cable pull to keep it out of sight.
 

·
Registered
Joined
·
1,128 Posts
If it is apart apart replace the rod for s&s crankpin, pinion shaft, and gear shaft with new stuff from s&s or Jim's.
 

·
Registered
Joined
·
1,128 Posts
Yeah bearings without a question. Look at us adding a grand to your motor
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top