Jockey Journal Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
991 Posts
Discussion Starter · #1 ·
Still need to finish up mounting it, but this is one bad ass tank...bullet proof comes to mind. Thanks again Trent! Sparky Moffett has the tank is laying down some paint for me. Should be ready for Willie's Tropical Tattoo Bike show.
 

·
Registered
Joined
·
801 Posts
Nice! And it matches your beefy pipes. Are those rolled tips, or is that some thick ass stainless tubing?

Mike V said:
Still need to finish up mounting it, but this is one bad ass tank...bullet proof comes to mind. Thanks again Trent! Sparky Moffett has the tank is laying down some paint for me. Should be ready for Willie's Tropical Tattoo Bike show.
 

·
Registered
Joined
·
991 Posts
Discussion Starter · #5 · (Edited)
those are actually just muffler shop exhaust pipes that I got for the bends and then polished them. I had some 1/4" thick - 1 3/4" washers that were sitting in a bin, they looked perfect so I welded them in the ends.


thanks.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top