Jockey Journal Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
498 Posts
If you're using the correct 0.100" thick O-ring on the carb flange,you'll have about 0.050" gap between the flanges.You should be able to rock the carbs when they're tight enough.It reduces float bowl vibration as well as heat transfer,and it's a good system.
Don't overtighten and bend the flanges.If you bend the flanges,the throttle slides can stick.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top