Jockey Journal Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,238 Posts
just wondering on the baring housing on the neck and if it should be covered/protected or is it all good?

I used 2 lg. dia. fender washers with a length of allthread to protect inside the neck, I think I also used it when I powdered coated it.
 

·
Registered
Joined
·
1,238 Posts
the bearing races should never be powder coated, any good powder coating company should know better and mask them off.
Your right Tony, I also had the powder coat company sand blast the frame,and wanted more protection for the races during the sand blasting.Just being over protective I guess.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top