Jockey Journal Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
726 Posts
Discussion Starter · #1 · (Edited)
Does anyone have a wiring diagram for an 6v system that was switched to 12v? I'm running a 12v system with Bosch reg and points but it seems I can't find a diagram that makes sense.

The ones on the site listed below don't make sense. maybe it's because I don
't have a horn or dimmer siwtich but the hot lines run out of the ACC on the switch and then go to the ligts and then coime back to the IGN on the switch. Don't they ahve to go to a ground after the light?

It took me at least 20 kicks tonite and if I got the RPM's up it would blow a fuse....

http://www.jammerclub.com/nohassle.htm
 

·
Registered
Joined
·
726 Posts
Discussion Starter · #5 ·
PONY said:
Not a problem. I'm running a Bosch regulator/2 brush/12v on my 56 PanShovel that used to be a 6v system. The regulator is on a factory bracket behind the rear cylinder, I looked for a sporty bracket that mounts on the generator but couldn't find one.
I'll look through my junk pile to see if I can find an extra one.
 
1 - 3 of 3 Posts
Top