Jockey Journal Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter · #1 ·
Hi guys. The previous owner of my t100 did a piss poor job on mounting the pipes. I'm in the process of trying to remove and rework them and am having trouble getting them off.

I've undone the clamps down low (there were two) and also loosened the finned header clamps (I can move them up and down the pipe) so the only thing holding the pipes is the fitting at the heads, but I can't seem to get the pipes off the heads.

I'm assuming it's just a pressure fit keeping them on at this point, but don't want to damage anything by getting to agressive. Got any pointers?
 

·
Registered
Joined
·
32 Posts
Discussion Starter · #4 ·
Thanks. Tried the WD-40 already, but haven't given up yet.

I don't think there's a set screw, but good suggestion. I'll check in case it might just be out of sight.
 
1 - 4 of 4 Posts
Top