paughco, ironhead and chopper stuff!

brand new paughco frame for 77+ ironhead only had it a month but changed direction, its a s120 with big twin neck, and fat bob gas tank mounts stock rake. i got boned 60 extra for the fat bob mounts because its all they had in stock.. can take either front end and any pre 77 motor if you add peg mounts. 700.00 obo and ill make the shipping a sweet deal.

SOLD!!!!sweet ass seat for shovelhead nice shape no damage.60.00

33.5trees lil wear at the top of stem,wont be an issue with timken bearings, sporty stem.60.00

SOLD!bad ass chopper air scoop,nice chrome needs a little repair on the back side where it cracked around theh mounting hole,wont be seen, easy to make a backing plate for your carb 40.00

SOLD!ironhead presto starter setup works good newer drive 75.00

33.5 lower legs,about the nicest ive seen nice chrome no rash a couple very small blemishes from use but again very nice 100.00

GONE!!!fork bracefor 33.5..some idiot put some hammer tracks in it but can clean up..10.00

SOLD!turtle tank good shape clean inside 25.00 WTF?

GONE !bolt on rear loop for ironhead, looks tweaked to one side,5 minuts with some heat would fix it,good start to a weld on. 40.00?

t bars with indents cut about 4 inches off each side and you can be cool.20.00

SOLD..old style sportster hub complete.would be rad drilled out,ill cut it out of the rim.40.00

GONE dual headlight with rusty bracket. dont make me throw out this rad chopper piece 10.00

all prices neg.worst ill say is no.
also have a nice early 70s sportster frame for choppifying ,just wating for the numbers to come back if any one wants it cheap. and please if you say you want somthing please check with the old lady first so you dont have to pimp me when she says no!
this is the tank:SOLD