Jockey Journal Forum banner
1 - 1 of 12 Posts

· Registered
1,206 Posts
Number one way to get a good seal?

Set up your other mounts properly. Bend tabs as needed, use spacers/washers as needed to get the exhaust positioned perfectly at the head junction. Use good fasteners and keep 'em tight. You can tighten the clamps better this way and you're not loading up the exhaust ports which can break them off.

After that, the other things that have been mentioned apply.

1 - 1 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.