Jockey Journal Forum banner
1 - 10 of 10 Posts

·
Registered
Joined
·
2,446 Posts
Any info on this piece ? Made in the 70's , bolts onto the BT swing arm frame and uses a Servi-car rear. Anyone have pictures of one installed on know who made them ?

Thanks

***UPDATE**

ok unboxed it,,outside to outside top 7 1/4" wide ....on bottom 8" wide

Label says something _____ Custom Cycles Kearny , New Jersey

Seem like it's for early swing arm




 

·
Registered
Joined
·
2,888 Posts
Any info on this piece ? Made in the 70's , bolts onto the BT swing arm frame and uses a Servi-car rear. Anyone have pictures of one installed on know who made them ?

Thanks
Custom Cycle Engineering (Randy Smith) made trike sections, I don't know if that's one of his or not. I'll try to dig up an ad and check.
Larry T
 

·
Registered
Joined
·
5,193 Posts
Custom Cycle Engineering (Randy Smith) made trike sections, I don't know if that's one of his or not. I'll try to dig up an ad and check.
Larry T
I remember there was a thread onhere from a CCE trike section..it had adjustable swivel connections.. there was a picture also from somebody who had one..
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top