New Member

My main question pertains to installing an open belt primo primary drive. One of my brothers hooked me up with the setup and we installed it a year or so ago. I ran the bike less than 100 miles (worked fine) then I tore it down for some tlc last fall. I didn't get back to it till recently and can't remember (didn't take pics) if there was some type of spacer between the clutch hub and tranny shaft support. Brother died so can't ask him. When installed I have close to 3/4 inch between the hub and support. Can anyone confirm that's ok? Thanks

What's up? And where in Pa are you? Alitta heads up, PICS are your best friend here. And make sure they are clear and specific of the issue or question at hand. TRUST ME.

Junklover said:

What's up? And where in Pa are you? Alitta heads up, PICS are your best friend here. And make sure they are clear and specific of the issue or question at hand. TRUST ME.

Click to expand...

Hey Junk, I'm in the Altoona Pa area mountains not town. Yeah I was thinking about pics as I was writing my question and was going to post some but living the bizarre life I have not a half hour after posting that I got a phone call from a brother that needed a hand . Long story short I went and helped him and another guy with a situation that popped up with their shop/shed and before I left last night I was handed a stack of shims and some knowledge that I believe will get me up. Thanks for your response and if nothing else finding this site gives me another source of information and like minded people. Crazy world we live in.

Definitely a crazy world for sure. Maybe we'll cross paths sometime. Im in the Pgh area. The 3\4 space between the hub and support sounds about right. There Is no spacer in there.