Jockey Journal Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
172 Posts
Discussion Starter · #1 ·
Hi All

Anyone fitted or know if these kits have provision for pressure lubricating the exhaust tappets ?

I have the new Morgo .pdf, and while it mentions dowels, its not very clear & to me it read's like instructions for a Chinese bicycle.
"make sure the con-rods are not bent by passing a rod through one into the other....Stubbs silver steel will do the job well" I don't know what the hell that means ?

any help greatly appreciated
 

· Registered
Joined
·
172 Posts
Discussion Starter · #5 ·
Thank you for all the help guys, every bit helps and I do appreciate it.

As usual my slightly odd sense of humor has distracted from what I was asking.

When I read "make sure the con-rods are not bent by passing a rod through one into the other" I just go to the bench and do something like this with a kinda stupid grin on my face.


(honestly that is just plain worded badly)

What I really need to know is...
Do the Morgo MkIII & 850cc ROUTTE kits have the oil ways drilled for pressure fed lubrication of the tappets or are they blanked off like the MAP kits?

Would be great to hear from anyone that has fitted one lately.
 

· Registered
Joined
·
172 Posts
Discussion Starter · #9 ·
I have a morgo kit and its not drilled for a tappet feed, i don't know what mark mine is though, morgo answer emails very promptly though and should be able to tell you in a minute.

What cams are you using ?
Thanks Bon.

You guys have pretty much answered my question.

What cams am I using ? That is the question....

I have some old NOS sports cams I want to use, I'm concerned they may not be hard so I'd like to get a little oil to them.
So do I ditch them altogether, buy something else, I also have 10 stud barrels and heads I could use....

At this stage I'm just thinking
 

· Registered
Joined
·
172 Posts
Discussion Starter · #12 ·
If you used the 10 stud top end you'd have to change to the shorter conrods too, all you need to change with the morgo kit is the exhaust cam to a nitrided type.
Thanks mate. will keep the T140 Rods in mind....have some steel ones around here somewhere, horrible on a road bike, but like I said I'm just thinking at the moment.

hopefully this bike will be my daily rider. I have a couple of rollers & I just bought some nasty mismatched cases, so we will see where it ends up.

Going to clean the cases up tomorrow and start from there
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top