[ElekVins]

Hi,
I'm currently shaving a set of 35mm lower and I'm thinking about filling the hole where you drain your fork oil...
I know it's alloy foundry, so It'll be TIG welded.
My question is, does anybody here have done it before?
Is there some problems (or advantages) that appears after doin' that beside the fact that you must dismantle your forks to bleed your oil after that?

 

[ElekVins]

yes, that's why I don't see the point to keep those screws...
did you have the experience of filling some of those holes?

 

[ElekVins]

Ok guys thank you for your opinion, I'll weld those holes !
I'll tell you if I find any problem after that, but I doubt it...