Jockey Journal Forum banner
1 - 1 of 1 Posts

1,308 Posts
Discussion Starter · #1 ·
Looking to sell my Miller Syncrowave 300 Tig
in excellent working condition,
comes with foot pedal, 25ft tig torch, thumb control, heavy duty ground clamp with cable,
voltage disconnect switch ( to wire machine from the circuit breaker the correct way) and is mounted on a dolley with heavy duty wheels to move it around.
basically just add a bottle with some gas and your ready to start welding
the faceplate is a little faded but you can still read all the dials and controls just fine
the paint is faded as well but the machine works perfect

machine does AC and DC for steel and aluminum,
goes up to 375 amp output, high frequency start
super heavy duty machine,
you could use this to repair cylinder heads, aluminum engine blocks, aluminum manifolds etc.

Looking to get $1050 or best offer on it, if your interested make me an offer
I have seen similar machine recently sell on ebay for $3000 that come with no accessories, I easily have about $500 in accessories with the foot pedal, thumb control, tig torch, and ground clamp and cable, and the wiring disconnect switch,
I will also throw in some 1 gauge 3 wire length of about 25 feet so you can wire into your electrical panel (this wire is not cheap by any means)
runs on a regular 220 voltage line single phase

only selling because I want to downsize and get something that is portable
attached are some pics
more pics available upon request I just need your email address

email if your interested I would gladly let anyone come over and take a look at it in person
located in Seaford, NY

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.