Jockey Journal Forum banner

Making a swingarm 45 frame

1K views 6 replies 7 participants last post by  Neo Dutch 
#1 ·
Has anyone made a 45 swingarm frame?
I have the front of a servicar frame, from the trans casting and top seat post casting forward,including a complete springer front end
I have been tossing around the idea of making it into a swing arm frame.
Anyone have any suggestions?
 
#7 ·
I chopped that thing up before Xmas. While the concept might have been cool the execution was "typical" 70's. The gap between the rear of the gearbox mount and the swingarm pivot was bridged by welding in a large nut.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top