Jockey Journal Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
161 Posts
I am in the middle or wiring my bike and need to know how to wire the bosch regulator. I see that there are 5 terminals but I believe that I only need to use 3 of those terminals. 2 from the generator and 1 to the battery at the ignition. Just not sure where to place those wires. I am running a battery and distributor on my kick only 66xl. also not sure on which is the field and ground on my generator. please help me get her going. thanks.
Ok I'm going out to my garage shortly and I will get you the exact terminals but i also wanted to make sure you know that the terminal on top is a ground and that it has to be grounded or else it won't function correctly. Make It a good ground too
 

·
Registered
Joined
·
161 Posts
Ok
A terminal from gen goes to the d+
F goes to df
Battery goes to the B+ and I ran another wire from the same point to the key switch
The terminal labeled 61 on the bottom left has nothing going to it
The ground is the one on top next to the mounting bolt. Very important.

Mine is a 72 kick only but not a distributor. Bosch regulator.

Also dont forget to polarize the gen after everything is hooked up. Mine is a cycle electric gen that never has to be polarized.

"Generator on motorcycle and connected to regulator: Connect one end of a jumper wire to the generator armature (A) terminal. Momentarily touch the other end of the jumper wire to the positive terminal of the battery.This restores the magnetism.Remove jumper"
 
1 - 2 of 2 Posts
Top