Jockey Journal Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
2,446 Posts
Discussion Starter #1 (Edited)
Ok, salvaging this 18" invader ( #'s inside look like 200 or 206 ) any ways , Main question, it seems the bearings are 40mm OD,,and that I need 3 ( including the one in the brake drum ) but I do not know how thick they are . Anyone know that measurement ? I'm thinking 12mm,,also were there dust shields on invaders ?

Also will be running a 17mm axle ,,does anyone have a bearing # for 40mm

and if anyone has a brake drum for sale that would help,,lol

Thanks

( so happy we have power again )
 

·
Registered
Joined
·
2,012 Posts
Look up bearing supply houses in your area. You could walk in with wheel in hand and they might have what you need. Know your axle size tho.
 

·
Registered
Joined
·
364 Posts
I agree with La Dolce and you can use an inside micrometer. Good tool to use.
 

·
Registered
Joined
·
2,446 Posts
Discussion Starter #4
Already found the size thanks,,,and as I posted I knew the size ,,just not how wide they were suppose to be..
 

·
Registered
Joined
·
647 Posts
And you are going to need a spacer in the middle.
I could be wrong, but I don't believe your drum would have a bearing.
 

·
Registered
Joined
·
2,446 Posts
Discussion Starter #6
And you are going to need a spacer in the middle.
I could be wrong, but I don't believe your drum would have a bearing.
Yes,,was thinking the same,,from what I have seen the drum does have a bearing as well
 
1 - 7 of 7 Posts
Top