Jockey Journal Forum banner

"hypothetical" question

3082 Views 22 Replies 18 Participants Last post by  SnoDawg
lets say you were drilling a hole in your backbone for a bung to mount your tank. lets also say the hole was off and needed to be ovaled to make the tank sit straight. would you have any issue welding up the resulting gap with your tig welder?
1 - 1 of 23 Posts
Could you grind on your bung a little and and straighten the tank up??? And no I wont say
1 - 1 of 23 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.