Jockey Journal Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
45 Posts
Discussion Starter · #1 ·
I bought a set of used gears off flea-bay for a older harley 4-speed, and when they show up all looks good except for 1st gear bushing. The bushing falls out of gear and the gear spins on the bushing. Does anybody think that a new bushing will be tight in the gear or have the measurment of the gear. Seller said it was supposed to be this way. Just wanting opinions before ordering a bushing or disputing payment options.
Thanks,
Clyco303
 

·
Registered
Joined
·
45 Posts
Discussion Starter · #3 ·
I was just going by the old gear set that I was replacing (1946) and the bushing seems to be a press fit. Old gears have lot of pitting. Just learning about harley gears, and didn't look right. Thanks for the info, the new gears are mid 60's so we'll go with them.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top