Jockey Journal Forum banner
1 - 2 of 2 Posts

· Registered
107 Posts
Discussion Starter · #1 ·
I am just starting my first Bobber project and I plan to weld tubing on the back of a 1974 CB 360 to make it into a rigid frame. I want to use DOM seamless structural round steel tube 1"od x 1/8" wall x ¾ " id.
Will this tubing be strong enough to do the job?
Thanks Fred


1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.