Jockey Journal Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
Newbie here. Been on the HAMB for a little bit and have made the jump to here now. Been into bikes for the last 10yrs. Been customizing my sportster, built a yamaha chopper from the ground up last year (may have seen in on the cover of Chopper Undergound), and just finished a buddies sporty earlier this year. Just started into Hot Rods late last year. Here are some links to the yamaha build and my sportster. Starting a little chopper shop in SE Iowa. Let me know if any of you are in the area.

Yamaha XS650
http://community.webshots.com/album/93761774aeZjPH

95 1200 sportster
http://community.webshots.com/album/116533702fBvTKe

Model A
http://community.webshots.com/album/254917858nyAIMM

Thanks
Matt Wilson
King Pin Customs
 

·
Registered
Joined
·
16 Posts
Discussion Starter · #4 ·
Thanks... the rear fender pivots during suspension travel and also achieves the slammed rear fender look like you see on alot of rigids. Took me a few tries to get it right but works great now. Even strong enough for saddlebags or a trip accross contry. The sprotster has almost 90,000 miles on it.

Thanks
Matt Wilson
King Pin Customs

TNsportster said:
I like what you did to the back end of your sporty.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top