Jockey Journal Forum banner

exhaust bracket

862 Views 3 Replies 2 Participants Last post by  rockett
4
needed to quiet the ride down a bit so i picked up some mufflers on the cheap and made some brackets out of some pieces i had rejected wile making some mids...

Attachments

See less See more
1 - 4 of 4 Posts
It looks good. What did you screw them to? Is that a self-tapping screw? Hard to tell from the pic.
It looks good. What did you screw them to? Is that a self-tapping screw? Hard to tell from the pic.
used regular bolts and attached it to the motor moutn plate using the hole under the peg thati think originally bolted to the rear framee section...
Nice! Good call. Always good if you can avoid drilling new holes. I'm not overly familiar with triumphs, so I wasn't sure what I was looking at. Clean look, sir.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top