Jockey Journal Forum banner
1 - 5 of 5 Posts

524 Posts
Discussion Starter · #1 ·
So I adjust my clutch (Evo, stock) by:

1. Lossened the cable at the adjuster and provided slack.

2. Turned the clutch adjsuter screw (at the primary) clockwise, maybe to far or not enough, then back counter clockwise about half a turn. I tightened until it was very snug before the counter clockwise turn, then re tightened the locknut.

3. Adjusted the cable out to provide about an 1/8" of play in the clutch lever.

I tested the bike and the clutch drags ass big time. Should I adjust at the adjuster screw or the cable to get rid of the drag?

I may have just opened a major can of worms here. Hopefully not.
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.