Jockey Journal Forum banner
1 - 1 of 1 Posts

150 Posts
Discussion Starter · #1 ·
new pistons,rings,pins,wassel pushrods,nos head,guides,stainless valves,springs,keapers,spring cups? top and bottom, qpd belt drive,sparx alt and reg

bottom end feels okay .004 crank end play and the rods have no detectable up and down movement.....i think it will be fine(fingers crossed)

went over the trans and swapped out the main shaft and one gear
the main shaft was hammered on the clutch side ......looked abused

just gotta put the inner and outer timing covers and related parts back on

pics shortly

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.