Jockey Journal Forum banner
1 - 11 of 11 Posts

·
Registered
Joined
·
82 Posts

·
Registered
Joined
·
1,262 Posts
Bcak to the one on ebay . If you look close you can tell that the rear axle mount welds are nice but are going the wrong way for the load . They should be a 50/50 push weld not a single down pull weld . And the way the axle plates are finished show a real lack of quality . Any ways I've heard nothin but good things about chopperhead .
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top