Jockey Journal Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1,321 Posts
Discussion Starter · #1 ·
I have a servi trike frame that Im looking to put together, it was chopped a long time, I would like to put the neck back to stock rake, (especially that one of the welds is slightly cracked on the bottom)

does anyone know what the stock rake angle or around what the stock rake angle is ?
 

·
Registered
Joined
·
102 Posts
Have a stock '47 in a building I could check and get back to you. If that would help, let me know. Its a complete machine though(not a bare frame).
Kev
 

·
Registered
Joined
·
42 Posts
I have the front Half of a servi frame some where in the garage.From the seatpost casting and trans mount forward. Rear sectin was taken off of the casting. not cut off
What measurements do you need.
 

·
Registered
Joined
·
1,321 Posts
Discussion Starter · #4 ·
just looking for the stock neck angle
the frame I have is in great shape, but the neck was raked and it had a 12 over front end on it
I would like to get it back to original looking as far as rake and front end length are concerned
plus the bottom weld on the neck has a hairline crack in it so Im gonna put the neck back to stock and plate and weld it

if anyone knows what the stock angle of the neck I would greatly appreciate it
 
1 - 5 of 5 Posts
Top