Jockey Journal Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Guys - just rebuilding my 500 pre-unit triton and have a question about the cam timing.

The bike was built with E3134 cams inlet and exhaust. The bottom end is a T100 with an iron barrel and the head is a twin carb (I think from a T100R).

With these cams fitted I am guessing that I should not use the timing marks on the standard wheels but have to dial in different cam timing. Is there a 'standard' setting for moving the teeth timing on this convertion to E3134's?

Appreciat your help

Thanks

Jamie
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top