Jockey Journal Forum banner

BRASS "Meat Tenderizer" Risers

1218 Views 1 Reply 1 Participant Last post by  DopeDog
CityCoconut GRove
These risers are 4½" tall from top to bottom, 3½" from bottom to center & have a 1-3/4" diameter base.

They've been re-tapped to accept standard ½-13" riser bolts, up from their original smallish 3/8-16" thread size.

While they were originally SUPPOSED to fit 1" bars, I found them to be somewhere between 7/8" & 1" --- which left an unacceptable gap when they were fully bolted down.
I've since run a honing/sanding stone through the handlebar center hole to bring them up to where they cleanly fit 1" handlebars.

I need $200 for these, which includes FREE shipping via USPS Priority Mail to anywhere in the lower 48 states.

If interested, have questions, or need more pics --- please PM me or email at:

See less See more
1 - 2 of 2 Posts
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.