anyone have a big twin frame jig in twin cities area?

800 Views 1 Reply 2 Participants Last post by Greenbikemike, Mar 17, 2012

rmw667

Discussion Starter · Mar 17, 2012

heres the deal i'm setting up my frame(hardtail w/ repop axle plates) and as it sits my tranny sprocket and drum sprocket are a off by .250" with no more room left. i have thought about trying to offset it my self using some threaded rod through axle plates and the various holes in the plates themselves. there is a total of five rods i could get through the plates to keep tension and used to spread them with some heat, just dont wanna fuck it up.

it seems a jig would be much easier to keep things square, i'll buy beer and can kick in some cash for oxy/act.

Save

1 - 2 of 2 Posts

Greenbikemike

· #2 · Mar 17, 2012

here's two good ones....but I don't think beers gonna do it,

Gilby's in River Falls

http://www.gilbysstreetdept.com/

Donny Smith

http://www.donniesmith.com/

Save

1 - 2 of 2 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month