Jockey Journal Forum banner
1 - 1 of 26 Posts

· Registered
947 Posts
In a pinch you can take a punch and smash the corners back in . Or I sometimes use a chisle and just catch the out side of the bolt . Then tap it out using the burr .

And on a 72 motor you don't need to go to a distributor to get a bolt kit . It take SAE 1/4 -20 bolts you can get in stainless at your local ACE hardware store .
1 - 1 of 26 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.