Joined
·
249 Posts
Matt find a Mac dealer and look for a damaged screw remover...it is part # P2019..it is a reversible drill bit made especially for phillips heads...I have only used this kit once but it did work...most times I just center punch the bolt or screw and drill it out...and if there is not enough pertruding to get a vise grips on it I cut it flush close as you can to the case and center punch it again drill it almost to the size of the threaded hole heat it with a torch let it cool then use a EZ out...and if you still can't get it out yet drill it out until it is almost into the threads and chase it out with a tap...there is no room there on a cam cover to slot the screw with a dremel unless you wanna cut up the cam cover...try the above before you use a dremel...
