[Dullboy]

Hey guys, I'm running 71 OIF forks and I want to run something other than the p clamps. I want to run a set of Biltwell risers that use a 12mm bolt. The issue being, the bushing diameter is too small for the bolt. I could have something machined with a 3/4 of and 12mm id but 1 was hoping to find an easier alternative. Does anyone have any ideas?
TIA

 

[Sluggo503]

Not sure what you were hoping for but your only option is to make a bushing machined for OD/ID. But worth considering using materials that isolate vibration