'68 T120R Top End '69 Bottom

969 Views 3 Replies 4 Participants Last post by shades34, Mar 21, 2012

Hellaflush08

Discussion Starter · Mar 21, 2012

Does anyone know if a '68 T120R barrel, head, push rods, tubes, Exc would bolt up to a '69 complete bottom end without causing any problems? I read somewhere there were changes made to the push rod tubes in '69 but they didn't mention what exactly. Does anyone if this setup would work? And if not why or what would need to be changed? Thanks in advance

1 - 4 of 4 Posts

Lindy

· #2 · Mar 21, 2012

If your going to use the 68 push rod tubes, lifter blocks and head then yep it will bolt on

Jay Everyday

· #3 · Mar 21, 2012

Just be sure to use the right bolts as well. I read on one of my posts that they went to unified in 1969?

shades34

· #4 · Mar 21, 2012

unified was mid 68, I don't know if there is an engine # anywhere but later is unified, otherwise the first post is correct.

1 - 4 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.