Jockey Journal Forum banner

65 XLCH Cam Question

787 Views 2 Replies 2 Participants Last post by  akchopper
I recently pulled a set of cams out of a 65 XLCH. The #1,#3, and #4 cams were P cams, but the #2 cam was an XL. I've been told that this was a stock setup for 1965. Something the factory did to make them easier to start. I'm wondering if anyone can confirm, or deny this as a factory setup. I've searched this site, as well as online, and I can't find any info on early Ironhead cams.
1 - 3 of 3 Posts
That was the correct set-up. It was changed to all 4 "P" cams after they went to a magneto with a manual advance. The early fixed mag models were like the one you have.
And all the information is in the parts books!
Robbie
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top