From the exasperatingly little I can see of it, that is a very good-looking bike! Have you stuck up any pics of it elsewhere on the JJ (and if so, where please)?
53 pan head project
Hey now from NJ,
Finally getting to my pan head project, and looking for some guidance.
53 pan head with super B carb. I purchased it in 2019 as a future project. Last owner said it was rebuilt into a stroker some time ago.
Bike was a bit difficult for me to start at first, but figured it out. Rode it a few times then noticed a valve cover leaking. Decided to put it away until I finished a few projects.
Here’s a video link of it running before I put it away back in 2019.
So now it’s really hard to start. Have to full throttle prime kick multiple times and kick start it flooded just about.
Also, it wouldnt idle without the enrichment up. I had to run idle screw in so it would idle. Didn’t need to do that before. Here is a video link:
So I pulled the plugs to get some ideas on issues. They looked fouled from running rich. what you guys think?
![Automotive tire Wood Auto part Fashion accessory Metal]()
Also did a compression test. About 90 psi on both cylinders. Front was a little higher than rear.
![Watch Automotive tire Gauge Automotive lighting Clock]()
![Watch Light Gauge Motor vehicle Measuring instrument]()
So my plan is to go over ignition system and rebuild carb. Bought a rebuild kit.
![Font Gas Soil Transparency Rectangle]()
![Wood Gas Road surface Space Asphalt]()
Any advice/tips/experience would be greatly appreciated.
once I get it running better I will be looking for advice on replacing valve cover gaskets. I’m assuming the engine will have to be removed, but will be looking for guidance from you all.
Please provide thoughts and I will update you all with updates
hope to hear back. Thanks guys
Finally getting to my pan head project, and looking for some guidance.
53 pan head with super B carb. I purchased it in 2019 as a future project. Last owner said it was rebuilt into a stroker some time ago.
Bike was a bit difficult for me to start at first, but figured it out. Rode it a few times then noticed a valve cover leaking. Decided to put it away until I finished a few projects.
Here’s a video link of it running before I put it away back in 2019.
So now it’s really hard to start. Have to full throttle prime kick multiple times and kick start it flooded just about.
Also, it wouldnt idle without the enrichment up. I had to run idle screw in so it would idle. Didn’t need to do that before. Here is a video link:
So I pulled the plugs to get some ideas on issues. They looked fouled from running rich. what you guys think?
Also did a compression test. About 90 psi on both cylinders. Front was a little higher than rear.
So my plan is to go over ignition system and rebuild carb. Bought a rebuild kit.
Any advice/tips/experience would be greatly appreciated.
once I get it running better I will be looking for advice on replacing valve cover gaskets. I’m assuming the engine will have to be removed, but will be looking for guidance from you all.
Please provide thoughts and I will update you all with updates
hope to hear back. Thanks guys
