Jockey Journal Forum banner

1967 T120R Front Wheel Alignment Problem

2411 Views 13 Replies 8 Participants Last post by  Swan
Hi folks, in a bit of a pinch with my new front wheel. Long story short while the bike is a 67, I'm using 69 upper & lower trees, TLS front brake setup, new axle, new fork seals, new bearings and hardware, lower members and brand new fork tubes. I just had the front rim laced, balanced and trued so it *should* be good.

Anyway, when I mount up the new wheel to the members and center it between the forks, everything looks good but as soon as I tighten up the lower member axle retaining bolts on each side the whole wheel (as looked at from the front) tips to the right about 1/4" leaving about 1/8" clearance on the right and about 1/2" on the left.

Any ideas what could be going on here and how to fix it?
1 - 1 of 14 Posts
Just to see what's going on I would tighten the cap on one side only and see what's happening on the other side.
1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top