Jockey Journal Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results
  1. Parts For Sale
    CityHillsboroStateILPrice1200/tradeCNC machined billilt evo style heads up to 127 cu inch. Large bore bolt pattern, Already machined with compression release holes, ready to go. I think these would fit on an ultima big bore bottom end and likely an s&s big bore bottom. Know what you're getting...
  2. The Board
    i have a 66 shovelhead, its setup for big bore jugs and heads. i think it was at 96 inches. i was wondering if anyone knows if i can go back to 74 inch jugs or 80inch jugs? im pretty sure the cases have been machined to fit the big bore jugs. if it is not possible to go back to the stock size...
  3. Parts For Sale
    CityOsage CityStateKSPrice1000I have a set of stock 74 in wheels w/ a new set of S&S rods and crankpin, new jims pinion shaft, and a set of KB 3 5/8 pistons ( KB930). I did all this work to what I was told were 80 inch wheels that I never took the time to measure my mistake. I thought I would...
1-3 of 3 Results