General Discussion
The Jockey Journal Marketplace
Vendor Member Section
Marketplace for Vendors.
Forum Support
Latest Posts
-
The BoardI heard about this pan 5 or 6 years ago I finally found it or it found me. Brought it home and took it down to the frame. Building it like something we rode in late 70’s. But with a few upgrades like the PM brakes. 1964 Motor stroked & bored to 94 inch runs great. It was a very nice bike but...
- 11
- 554
-
The BoardLike a lot of guys I'm having a hard time getting my Shovelhead clutch to work right. I can adjust it to release fully but then it will slip under a hard pull, if I adjust it so it won't slip, it won't release all the way. I have installed a clutch "retainer" and that helped some but it should...
- 29
- 1K
-
I picked up some information from a local harley dinosaur a few years ago, about the ‘misallignment’ from the rockers in the rockerbox, at this moment i have a few rockerboxes available for an exploded view to check the myth , wich tells the factory intentions where to angle the rockers a bit...
- 18
- 641
-
The BoardEvening all. As many of you are probably aware, I tinker way too much.. but after having all over my bikes longer, going back to a WL springer on the knuck the bike felt.. too small? I've came to the conclusion I prefer longer front ends!! So, one of my friends had a set of 4" over lowers...
- 20
- 812
-
The BoardOkay, this is going to wordy to start off. I inherited a box of Triumph from my father-in-law a couple years back. He's a Harley guy, so he didn't want it, but he bought it cause the guy was only asking $150 for it. Hence, I ended up with it for $0 (to start). The bike was somebody else's...
- 24
- 4K