Magneto install, no cam endplay? - The Jockey Journal Board

Go Back   The Jockey Journal Board > General Discussion > The Board

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 11-17-2011, 12:03 AM   #1
Terracite
Junior Member
 
Terracite's Avatar
 
Join Date: Jun 2007
Location: Whitecourt, Alberta
Posts: 20
Default Magneto install, no cam endplay?

Putting new hunt magneto on brandy new evo. Before opening the gear case, I was curious as to what the factory end play on the cam was. I couldn't get a feeler between cam and thrust washer at the back. Smallest feeler I've got is .0015 . So, I naturally assume I'm the problem, and it'll be obvious once the gear chest is open.



Gear cover came off no prob., all seems well, there are no shims on the outboard end of the cam, and new mag cover goes on with some tightness on cam bushing, but torques up ok with the old gasket on.

End play is still 0, or really close to it.

What now? Is there some way to make sure the cam is snug against the cover?
Terracite is offline   Reply With Quote
 

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -5. The time now is 06:56 PM.