The Jockey Journal Board - View Single Post - Pinstriping one shot question??
View Single Post
Old 11-28-2012, 12:03 PM   #9
FlameThrower
Senior Member
 
FlameThrower's Avatar
 
Join Date: Feb 2010
Location: Doylestown, Ohio
Posts: 298
Default Re: Pinstriping one shot question??

If you used the hardener with the One-Shot, I would like your chances. Without it... my experience is that it will likely wrinkle around the edges a little/lot almost no matter what you do when spraying the clearcoat. That's why i only use HOK striping enamel... I've literally NEVER had it wrinkle when I clearcoat over it.

Good luck, man. If you go for it, allow it to sit a few days and spray the first couple coats of clear VERY lightly in hopes it will "seal" out the solvents from the later, heavier coats.

www.flamethrowercustoms.blogspot.com
www.flamethrowercustoms.com
FlameThrower is offline   Reply With Quote