The Jockey Journal Board - View Single Post - Bench Grinder
Thread: Bench Grinder
View Single Post
Old 03-15-2020, 02:08 AM   #5
JonesL
Junior Member
 
Join Date: Feb 2016
Location: California, USA
Posts: 14
Default Re: Bench Grinder

Fine grain aluminum oxide for HSS cutters. "green" Silicon Carbide for carbide cutters.
And keep the green stone for carbide only, the aluminum oxide wheel for HSS only.



Tin can full of water close at hand so you can keep the temperature down and not take the temper out/soften the cutter.



To get rid on microscopic scratches from the wheel, a diamond hone is a good idea to lap the cutters after sharpening and before use.
Machinery's Handbook can also tell you about the importance of chip breakers and other sharpening tricks.
JonesL is offline   Reply With Quote