The Jockey Journal Board - View Single Post - Home made workshop tools
View Single Post
Old 11-07-2010, 01:04 PM   #114
knuckleworks
Senior Member
 
knuckleworks's Avatar
 
Join Date: Nov 2010
Location: sweden/kristinehamn/wärmland
Posts: 790
Default Re: Home made workshop tools

Quote:
Originally Posted by Lucky59 View Post
//janne

Awesome tool/design, thanks!

Have a question. How good a fit do you need between the 32x32 bar and the 40x40x4 tube that it slides into, and how do you get the inside weld seam out of the 40x40? I've taken the seam out of square tube before, but it was a bitch.

Guy
thanx
i have a wery complex way of dealing with that,,,,,,,, just kidding i use a 2,2 mm or similar cutting disc and make a groove in the 32x32 along it's entire length

when fabing the peices detirmine how you are going to put the 32 in the 40 right away and stick to that i tried to remove the weld first but to no need,the 32 fits firmly enough inside the 40
knuckleworks is offline   Reply With Quote