Originally Posted by govmule84
No, they're press-fit and that's it. No key. I actually don't know how the hell I'd keep 'em aligned right other than scribing a mark...
being from a few generations back in time - I can not figure out how to post pictures
the tool I have is self explanatory - you use the tool with movable pins @ zero and retard and advance to 10 degrees - and it uses the end cut out for the advancer that is zero to the cam lobes center at the heads up spot
TO install - you put the gear in what you want for timing on the pins that you set in place - and then the cam spud in the cut out location that is spring loaded - in the press and your done
I can send you pictures but I have no idea how to post them