The Jockey Journal Board - View Single Post - Right Tool for the Job type Question
View Single Post
Old 06-20-2010, 12:15 AM   #4
dinuns1
Senior Member
 
Join Date: May 2009
Location: Massachusetts
Posts: 949
Default Re: Right Tool for the Job type Question

Get a piece of brass 1'' od , have about 1/4'' of it turned down to .794 thats to fit in the Wristpin then have about 1.25 or a little longer than the width of the rod , turnedown to match the outside of the wrist pin but no big enough to ''grab'' the rod i think .801 will work and hammer out said wristpin .
dinuns1 is offline   Reply With Quote