The Jockey Journal Board - Search Results

Go Back   The Jockey Journal Board > Search Forums

Showing results 1 to 25 of 147
Search took 0.01 seconds.
Search: Posts Made By: flyingsquirrel
Forum: Wanted 04-07-2014, 10:34 AM
Replies: 1
Views: 619
Posted By flyingsquirrel
Re: WTB: Pre Unit Triumph Parts

Have the lower clamp...someone has drilled a 1/2 inch hole ion the front, center..probably to mount a light..$40.00 plus shipping
Forum: Wanted 12-20-2013, 12:40 PM
Replies: 1
Views: 676
Posted By flyingsquirrel
Re: T140 parts . crank, head and rocker covers

Have several T140 cranks but only 1 is out of the cases. Crank is rusty but the journals are not damaged as the rods are still on the crank...Crank by itself $100.00...With rods $200.00
Forum: The Board 11-12-2013, 10:41 AM
Replies: 11
Views: 2,573
Posted By flyingsquirrel
Re: 78 triumph leaking oil left side

Primary oils off the engine oil, put the primary cover on and no more oil leak
Forum: The Board 10-30-2013, 11:26 AM
Replies: 15
Views: 2,623
Posted By flyingsquirrel
Re: help with baffles - triumph

church-key baffles kill the performance. I prefer the straight through tube with the fiberglass wrap on the outside as it knocks the crack off but the exhaust still sounds healthy.
Forum: Parts For Sale 10-28-2013, 11:31 AM
Replies: 0
Views: 521
Posted By flyingsquirrel
Universal extended brake< clutch< cable kits

Extended universal control cable kits to build your clutch, brake or throttle cable for those really tall bars. Clutch and brake with .100 wire available in 66inch($14.00) or 96inch($18.00) housing...
Forum: Wanted 10-28-2013, 11:28 AM
Replies: 1
Views: 490
Posted By flyingsquirrel
Re: Amal Monoblock Parts Wanted

I have them both in NOS but you are looking at $65.00. Also have used $15.00-$20.00 for the pair, depending on condition, threaded or non threaded top cap??
Forum: Wanted 10-09-2013, 05:01 PM
Replies: 1
Views: 506
Posted By flyingsquirrel
Re: triumph rectifier,regulator?

Have new ones that I know are good, also have a bunch of used ones but I have no idea if the internals are good or bad as I have never had any of them on a bike.
Forum: Wanted 06-19-2013, 12:15 PM
Replies: 1
Views: 486
Posted By flyingsquirrel
Re: wtb bsa a65 cases

I have cases, but nothing with paper as the paper is supposed to go with the frame
Forum: The Board 06-07-2013, 02:15 PM
Replies: 5
Views: 1,108
Posted By flyingsquirrel
Re: Triumph single carb cable woes

You probably got a throttle cable for a Monobloc, they are shorter by quite a bit than one for a Concentric. Also, if you have an off the wall throttle, that might be the problem. I always use a...
Forum: The Board 06-07-2013, 02:08 PM
Replies: 16
Views: 2,028
Posted By flyingsquirrel
Re: Triumph stator not centered

Could be the studs are tweaked, I have drifted the studs over with light hammer application to get the correct clearance. It has worked for me before.
Forum: Wanted 05-28-2013, 11:39 AM
Replies: 1
Views: 470
Posted By flyingsquirrel
Re: WTB early 70's t100r right side case

I can fix you up with a matched set of late style T100 cases for $100.00 plus the ride
Forum: Wanted 05-22-2013, 12:13 PM
Replies: 1
Views: 555
Posted By flyingsquirrel
Re: wtd Amal 389 & top assembly

How nice a top ring?? most seem to have been attacked by various pliers in their life time. Do you want a top threaded for the adjusters or non-threaded for the cables with stepped ferrules???
Forum: Wanted 05-17-2013, 12:43 PM
Replies: 1
Views: 561
Posted By flyingsquirrel
Re: Triumph timing gear

Believe that I have a couple of those but to be sure can you give me the exact width of the gear
Forum: Wanted 03-18-2013, 11:32 AM
Replies: 1
Views: 397
Posted By flyingsquirrel
Re: Triumph trans & Carb Parts

Kickstart pinion gear and quadrant(less shaft) $25.00 plus shipping. Do you need the rod that pulls the slide up or something else???
Forum: Wanted 03-18-2013, 11:22 AM
Replies: 1
Views: 424
Posted By flyingsquirrel
Re: Wanted 1971 Triumph fork tube damper

$30.00 plus shipping, Can you give me the overall length to be double sure it is the correct one and not the trident one

www.bikesandbits-tn.com
Forum: Wanted 03-18-2013, 11:18 AM
Replies: 4
Views: 1,091
Posted By flyingsquirrel
Re: WTB Amal jet bloc 1 5/32" bore 389 monobloc

Have several to pick from, $20.00 shipped in the lower 48

www.bikesandbits-tn.com
Forum: Wanted 02-22-2013, 01:44 PM
Replies: 1
Views: 595
Posted By flyingsquirrel
Re: WTB triumph t120 650 piston wrist pin

Have one, still in the factory shipping cosmoline. 1.400 long. $8.00 plus shipping.
[email protected].net

fred
Forum: Wanted 02-19-2013, 10:10 AM
Replies: 1
Views: 408
Posted By flyingsquirrel
Re: WTB triumph primary cover (76 t140) left side shift

Have one, has the usual slight footrest ding that shows up as a slight crack on the inside, $40.00 plus the ride, also have a nicer one as well as a chromed one for more $$
www.bikesandbits-tn.com
Forum: Wanted 12-24-2012, 10:33 AM
Replies: 2
Views: 715
Posted By flyingsquirrel
Re: WTB Rigid Triumph Primary Cases

I have an absolutely beautiful inner for $200.00 plus shipping. Also have a thicker than stock reproduction outer cover, never used, for $250.00(thick enough that it will straighten out any warpage...
Forum: Wanted 12-24-2012, 10:21 AM
Replies: 1
Views: 451
Posted By flyingsquirrel
Re: Fuel tank for OIF Triumph

2 1/2 or 4 gal ??
Forum: Wanted 08-31-2012, 12:32 PM
Replies: 3
Views: 499
Posted By flyingsquirrel
Re: Primary chain for pree-unit trumpet

Standard 428 or 428H chain, should be able to get a length of that at most any motorcycle shop. If you know how many links you need, I can probably fix you up...Fred
Forum: Wanted 08-31-2012, 12:30 PM
Replies: 2
Views: 792
Posted By flyingsquirrel
Re: Triumph parts needed!

Have T140 con rod used $65.00, also have NOS $150.00. Have used 4 hole disc rotors, rusty but not scored $50.00. if you need pics drop me a line at [email protected]
Forum: Parts For Sale 08-23-2012, 01:48 PM
Replies: 0
Views: 6,962
Posted By flyingsquirrel
Metisse frame kits for Triumph BSA Norton

Newly manufactured, by Wasp engineering, a company with 50 years experience building custom motocross frames, Metisse frame kit as originally offered by the Rickman brothers in the 1960s. Like the...
Forum: Wanted 07-24-2012, 12:24 PM
Replies: 2
Views: 731
Posted By flyingsquirrel
Re: Need some random triumph parts

Pair used complete chain adjusters $25.00
Thropttle cables $11.00 each
Do you need just the bearings or the the cups and cones also for the fork head??
Forum: Wanted 07-11-2012, 04:41 PM
Replies: 3
Views: 1,127
Posted By flyingsquirrel
Re: Clutch Cable - Complete - for 1957 Triumph 650 Pre-Unit

Have the cable as a kit but not made up, and if you have a clutch lever with an adjuster, the stock, over the counter cabe, will not work
Showing results 1 to 25 of 147

 
Forum Jump

All times are GMT -5. The time now is 09:54 PM.