The Jockey Journal Board - Search Results

Go Back   The Jockey Journal Board > Search Forums

Showing results 1 to 10 of 10
Search took 0.00 seconds.
Search: Posts Made By: Ibop7
Forum: The Board 09-11-2019, 06:19 PM
Replies: 1
Views: 560
Posted By Ibop7
It will work fine. Get your alignment in order...

It will work fine. Get your alignment in order and red loctite the nut. Pull to book value torque.
Forum: The Board 08-07-2019, 08:25 PM
Replies: 13
Views: 845
Posted By Ibop7
I'm 100% voting the aquarium!

I'm 100% voting the aquarium!
Forum: The Board 06-25-2019, 04:45 PM
Replies: 23
Views: 1,450
Posted By Ibop7
Make sure that the notch in the spacer isnt...

Make sure that the notch in the spacer isnt touching the lip on the seal. Adding some RTV between the spacer and 4th gear groves helps stop weeping there too.
Forum: The Board 06-12-2019, 06:04 PM
Replies: 25
Views: 1,804
Posted By Ibop7
I have the VTwin unit on my 51 servicar. I didnt...

I have the VTwin unit on my 51 servicar. I didnt do the install so I can't tell you about that aspect. It has a small sealed battery that is an alarm system backup battery. I have had it close to 20...
Forum: New? Introduce yourself here! 06-11-2019, 08:51 AM
Replies: 1
Views: 433
Posted By Ibop7
Newbie

Howdy. I don't know if I did this or not so am doing now. I'm 76 years old and have been playing with Harleys for nearky 50 years. I have owned a motorcycle shop exclusive to HD and Indian for the...
Forum: The Board 06-11-2019, 08:16 AM
Replies: 8
Views: 753
Posted By Ibop7
Agree with that!

Agree with that!
Forum: The Board 04-24-2019, 06:04 PM
Replies: 71
Views: 3,094
Posted By Ibop7
Something to consider on your not return to idle...

Something to consider on your not return to idle issue is that if your points weight springs cant pull the the weights back in the motor will idle high until the weights can return. Try lubricating...
Forum: The Board 04-18-2019, 07:20 AM
Replies: 55
Views: 1,987
Posted By Ibop7
The thrust washer #15 belongs on the outside of...

The thrust washer #15 belongs on the outside of the cover with the beveled edge facing out. That is, to be clear flat side towards the cover, countersunk side towards the arm. I hope this helps as...
Forum: The Board 01-16-2019, 06:17 PM
Replies: 18
Views: 1,514
Posted By Ibop7
@ govtmule84. Isnt it there on the 47 knucklehead...

@ govtmule84. Isnt it there on the 47 knucklehead too?
Forum: The Board 09-07-2018, 07:31 PM
Replies: 41
Views: 3,122
Posted By Ibop7
Get into the timing first. The carburetor was...

Get into the timing first. The carburetor was running but spitting. It could be a lean condition but I doubt it on a start. Typically your bike starts easier with an additional squirt of fuel so it's...
Showing results 1 to 10 of 10

 
Forum Jump

All times are GMT -5. The time now is 04:01 AM.