Jockey Journal Forum banner

Acme Choppers Springer front end and Custom frames - Jockey journal special

14K views 4 replies 5 participants last post by  HD48FL 
#1 ·
*Custom springer front ends*
SUPERIOR QUALITY, WE USE ONLY THE BEST PARTS AND MATERIALS
...including:
*.188 wall thickness DOM tubing on rear legs*
*3/4" solid front legs*
*Stainless steel spring rods*
*Progressive rate inner and outer springs (8 springs per front end)*
*Delron spring rod isolators*
*Highest quality chrome hardware (Gardner-Wescott)*
*Timken-Torrington needle roller bearing lower rockers*
*CNC MACHINED PARTS*
*FULLY RADIUSED EDGES*
*ALL PARTS ARE PRECISION TIG WELDED AND FULLY COOLED IN FIXTURE BEFORE ASSEMBLY*
*YOU MUST MEASURE WHAT LENGTH FRONT END YOU NEED,
MAKING SURE TO TAKE INTO ACCOUNT ENGINE/TRANSMISSION AND RIDER WEIGHT

MEASURE FROM THE BOTTOM OF NECK TUBE (LOWEST POINT) TO CENTER OF AXLE (incluing tire height)

*available in wide or narrow configuration*
***available in chrome or powdercoat for additional charge***
our normal retail on these is twelve hundred bucks...
$1000.00 SHIPPED (lower 48)




 
See less See more
4
#2 ·
This thread is old as shit, but I just got a pair of T bars from these guys and they are top notch. The quality is great and the prices are very reasonable. Nice guys and quality work.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top