Wait?! What!? A long bike from Angry Monkey Motorcycles? Say it isn't so! Yep, it is for real, and it is also a "unit" bike to boot. This client build has been started for over a year but because of frame delays, outside of my realm of control, it is only now starting in earnest.
The plan is the client flying in, then riding this puppy out to Sturgis THIS June. Ambitious? Yes. Possible? Yes. That is, IF everything else falls into place on time. All I can tell you for sure is that I'm going to give it my best effort. So buckle up and enjoy the ride
This is the list of basics features on this bike:
Fully polished 650 bumped to 750 Engine built by Dan at Franz and Grubb
Sugar bear 18" over springer with #2 rockers,
46* degree rake, twin down-tubes, goose-necked, full frame, by Speed Devices
16" rear wheel w/firestone vintage tire,
21" front wheel w/Speedmaster tire and small disc brake (GASP!),
vertical oil tank
AMM saddle.
The rest will have to be figured out as we go, since this is my first Choppa'
Here are a few of the parts collected so far...
Donor bike: "tagged" frame, which will be sold off. Titled '70 engine.
18" over Sugar Bear Springer:
OG ARD setup on the right will go on this bike. The aftermarket ARD on left was sent to client for use on one of his other Triumph bikes.
Adam of Speed Devices finishing up the frame. WOOOO-HOOOO!
The plan is the client flying in, then riding this puppy out to Sturgis THIS June. Ambitious? Yes. Possible? Yes. That is, IF everything else falls into place on time. All I can tell you for sure is that I'm going to give it my best effort. So buckle up and enjoy the ride
This is the list of basics features on this bike:
Fully polished 650 bumped to 750 Engine built by Dan at Franz and Grubb
Sugar bear 18" over springer with #2 rockers,
46* degree rake, twin down-tubes, goose-necked, full frame, by Speed Devices
16" rear wheel w/firestone vintage tire,
21" front wheel w/Speedmaster tire and small disc brake (GASP!),
vertical oil tank
AMM saddle.
The rest will have to be figured out as we go, since this is my first Choppa'
Here are a few of the parts collected so far...
Donor bike: "tagged" frame, which will be sold off. Titled '70 engine.
18" over Sugar Bear Springer:
OG ARD setup on the right will go on this bike. The aftermarket ARD on left was sent to client for use on one of his other Triumph bikes.
Adam of Speed Devices finishing up the frame. WOOOO-HOOOO!