need sombody with a mill

[LUNCHBOX71]

i can send or post a link for a pic but here is the short story, my bike is running a sifton cast alum. brake up front. most of you who bought ez-rider magazine off the rack in the 70's know what this is. the hole for the axle and spacer has wollerd out over time and i need it bored out round and oversized for a brass bushing. i can make the bushing at work but i cant sneak a brake in there and set it up without the man giving me shit. thanks. ill pay ya for your trouble ..thanks

[Creepinogie]

Can't you drill it out on a drill press (or even by hand) and then use a reamer to get it to size? Usually they drill them 1/64th undersize and use a ream to get the final size.

[LUNCHBOX71]

if it comes down to it i will knaw it out with my teeth. lol. but im just thinkin best tool for the job. i should have done it years ago before i ran it. i knew it could use a bushing. livins learnin

[Trumpnut]

I OWN A MACHINE SHOP . So I can get it done for you just pay shipping

[LUNCHBOX71]

im gonna email ya. with pics. dont mind payin or trading some engraving work. you can see it at www.lunchboxengraving.com